音频控制和软开关的放大器

11-21| http://www.dianzi6.com | 电子电路图 - 控制电路图 - 开关电路电路图|人气:676

音频控制和软开关的放大器

相关元件PDF下载:


BC109C   LM380   BD131   


The soft switching is enabLED by a BD131 transistor wired as a switch in emitter follower configuration. The collector is wired to a permanent supply voltage, the 2H series inductor serves only to filter out power supply hum. This inductor is not too important and may be omitted if the DC supply is adequately smoothed. The control voltage is applied to the BD131 base terminal, the 10u capacitor and 10k resistor having a dual purpose:-
i) a gradual charge of the 10u capacitor ensures that the transistor will switch linearly from 0 volts to full supply, and
ii) serves as a hum filter ensuring a very smooth dc supply to the amplifier and tone controls.
LED1 will light when the amplifier is on. The control voltage should ideally be 0 volts when the amplifier is off and full supply voltage when on. The LM380 is shown driving two 8 ohm loupspeakers, the load is therefore 4 ohms. The 4u7 capacitor acts as a crude crossover, lower frequencies are impeded and so this loudspeaker may be a "tweeter" type.

如果觉得 音频控制和软开关的放大器这篇文章不错,可以推荐给朋友分享哦。
本文Tags:电路图讲解,电路图练习,电子电路图 - 控制电路图 - 开关电路电路图,
相关开关电路电路图资料


温馨提示; 本站的资料全部免费下载,为方便下次找到本站记得将本站加入收藏夹哦,牢记网址http://www.dianzi6.com

此页提供音频控制和软开关的放大器电路图讲解,电路图练习, 电子电路图 - 控制电路图 - 开关电路电路图参考。本站还有更多的开关电路电路图相关资料分享。
Copyright© www.dianzi6.com Inc. All rights reserved 。 1 2 3 4 5 6 7 8