2W 音频放大器(英文)

09-08| http://www.dianzi6.com | 家电维修 - 单元电路介绍 - 音频电路|人气:528

2W 音频放大器(英文)

Circuit Description

The amplifier operates in Class AB mode; the single 470R preset resistor controls the quiescent current flowing through the BD139/140 complimentary output transistors. Adjustment here, is a trade-off between low distortion and low quiescent current. Typically, under quiescent conditions, standby current may be 15 mA rising to 150 mA with a 50 mV input signal. A simulated frequency response is shown below:

2W 音频放大器(英文)

The circuit is DC biased so that the emitters of the BD139 and BD140 are at approximately half supply voltage, to allow for a maximum output voltage swing. All four transistors are direct coupled which ensures:-

(i) A good low frequency response

(ii) Temperature and bias change stability.

The BC109C and 2N3906 operate in common emitter. This alone will provide a very high open loop gain. The output BD139/140 pair operate in emitter follower, meeting the requirements to drive low impedance speakers. Overall gain is provided by the ratio of the 22k and 1k resistor. A heat sink on the BD139/140 pair is recommended but not essential, though the transistors will run 'hot' to the touch.

2W 音频放大器(英文)

如果觉得 2W 音频放大器(英文)这篇文章不错,可以推荐给朋友分享哦。
本文Tags:音频电路,电路设计,家电维修 - 单元电路介绍 - 音频电路,
相关音频电路资料


温馨提示; 本站的资料全部免费下载,为方便下次找到本站记得将本站加入收藏夹哦,牢记网址http://www.dianzi6.com

此页提供2W 音频放大器(英文)音频电路,电路设计, 家电维修 - 单元电路介绍 - 音频电路参考。本站还有更多的音频电路相关资料分享。
Copyright© www.dianzi6.com Inc. All rights reserved 。 1 2 3 4 5 6 7 8